Mesh inflation layer not shown - Project Support - SimScale CAE Forum

Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This

Which is the best CFD software? - Quora

Boundary Layer Does Not Form - Except When Default Settings Used - Project Support - SimScale CAE Forum

Your Guide to Meshing Techniques for Efficient CFD Modeling

F1 front wing CFD thesis Inflation layer problem - Project Support - SimScale CAE Forum

AEC Magazine September / October 2022 by X3DMEDIA - Issuu

SimScale - Another Fine Mesh

Week 3 - External flow simulation over an Ahmed body.

The emerging role of open technologies for community-based improvement of cryopreservation and quality management for repository development in aquatic species - ScienceDirect

Week 3 - External flow simulation over an Ahmed body.

7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software

Week 3 - External flow simulation over an Ahmed body.

What is a SolidWorks simulation worker agent? - Quora

Design and Analysis of Generic UAV Composite Winglet Structures

PDF) Independent Assessment and Benchmarking of no/low cost Finite Element Analysis Software for Linear Static Structural Analysis

Your Guide to Meshing Techniques for Efficient CFD Modeling