Input Shaper without effect?! - General Discussion - Klipper

Basic Information: Printer Model: Kingroon KP3S MCU / Printerboard: Kingroon KP3 V1.2 klippy.log klippy.log (20.1 KB) Describe your issue: Hi folks, although it says “Never change a running system” or something similar I changed the print head of this little fellow and swapped the RasPi 3 with an OrangePi Zero that was used on my CoreXY before. Before all this I think I found a good config in terms of input shaping. Due to changed mass of the print head I rerun resonance measurement

Tips for improving your input shaping that I've picked up over the

FYSETC Hardened Steel Tungsten Carbide Coating 0.4 mm Nozzle High

Input Shaper without effect?! - General Discussion - Klipper

Klipper in a duet2 wifi - General Discussion - Team FDM

Support Center Raise 3D Technologies Inc

Disabling axis when calibrating input shaper - General Discussion - Klipper

Input Shaper without effect?! - General Discussion - Klipper

The LDO input shaper toolkit provides all the necessary parts for performing Klipper input shaper calibration with minimal hassle. For detailed

LDO Input Shaper Toolkit (ADXL345) for Klipper

Update on Original Prusa XL Shipping, Input Shaper Alpha for the

Klipper Pressure Advance Tuning - How to Guide

GitHub - MagicPhoenix/EIS: Klipper Easy Input Shaper, provide a

I love Klipper and input shaping! I'm never going back to Marlin